Echo SHRED'N'VAC ES-210 Manual de usuario descargar pdf (Pagina 18)

0.65 mm

(0.026 in.)

C o o l I n g s y s T e m

Level 2.

Tools required: 25-50 mm (1-2 in.) cleaning brush, 3 mm hex

wrench, cross head screwdriver

Parts Required: None, if you are careful.

IMPORTANT

To maintain proper engine operating temperatures, cooling air must

pass freely through the cylinder n area. This ow of air carries

combustion heat away from the engine.

Overheating and engine seizure can occur when:

• Air intakes are blocked, preventing cooling air from reaching the

cylinder.

• Dust and grass build up on the outside of the cylinder. This build-up

insulates the engine and prevents the heat from leaving.

Removal of cooling passage blockages or cleaning of cooling ns is

considered “Normal Maintenance.” Any failure attributed to lack of

maintenance is not warranted.

Cleaning Grill

1. Remove accumulated debris from crankcase intake grill above the

fuel tank.

s p a r k p l u g

Level 2.

Tools required: T-Wrench, Feeler gauge

Parts Required: REPOWER

Tune-Up Kit

IMPORTANT

Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) other-

wise severe engine damage may occur.

1. Remove spark plug and check for fouling, worn and rounded

center electrode.

2. Clean the plug or replace with a new one. DO NOT sand blast to

clean. Remaining sand will damage engine.

3. Adjust spark plug gap by bending outer electrode.

4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sin comentarios

Echo SHRED'N'VAC ES-210 Manual de usuario Pagina 18