Echo SHRED'N'VAC ES-210 Manual de usuario descargar pdf (Pagina 17)

Sh r e d 'N' Va c

p e r a T o r 's ma n u a l

f u e l f I l T e r

Level 1.

Tools required: 200-250 mm (8-10 in.) length of wire with one end

bent into a hook. clean rag, funnel, and an approved

fuel container.

Parts required: REPOWER

Air and Filter Kit

DANGER

Fuel is VERY ammable. Use extreme care when mixing, storing,

or handling.

1. Use a clean rag to remove loose dirt from around fuel cap and

empty fuel tank.

2. Use the “fuel line hook” to pull the fuel line and lter from the

tank.

3. Remove the lter from the line and install the new lter.

a I r f I l T e r

Level 1.

Tools required: 25-50 mm (1-2 in.) cleaning brush.

Parts required: REPOWER

Air and Filter Kit

NOTE

Clean daily.

1. Close choke (Cold Start Position [ ]). This prevents dirt from

entering the carburetor throat when the air lter is removed. Brush

accumulated dirt from air cleaner area.

2. Remove air lter cover. Brush dirt from inside cover.

3. Remove air lter and lightly brush debris from lter. Replace

lter if it is damaged, fuel soaked, very dirty, or the rubber sealing

edges are deformed.

4. If lter can be reused, be certain it:

• Fits tightly in the air lter cavity.

• Is installed with the original side out.

5. Install air lter cover.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Sin comentarios

Echo SHRED'N'VAC ES-210 Manual de usuario Pagina 17