Echo SHRED'N'VAC ES-210 Manual de usuario descargar pdf (Pagina 13)

Sh r e d 'N' Va c

p e r a T o r 's ma n u a l

s T a r T I n g w a r m e n g I n e

The starting procedure is the same as Cold Start except DO NOT close

the choke.

1. Stop Switch

Move stop switch button (A) away from the STOP position.

2. Throttle Position Lever

Move throttle position lever (B) forward to idle position.

3. Purge Bulb

Pump purge bulb (D) until fuel is visible and ows freely in the

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4. Recoil Starter

Place the unit on a at, clear area. Firmly grasp throttle grip with

left hand and rapidly pull recoil starter handle/rope (E) until en-

gine res.

IMPORTANT

Recoil starter: Use short pulls - only 45 ~ 60 cm (18 ~ 24 in.) of

rope for starting. Do not allow the rope to snap back in. Always

hold the unit rmly.

NOTE

If engine does not start after 5 pulls, use Cold Start Procedure.

s T o p p I n g e n g I n e

1. Throttle Trigger/Throttle Position Lever

Release throttle trigger (F). Move throttle position lever (B)

forward to idle position and allow engine to return to idle before

shutting engine off.

2. Stop Switch

Move stop switch (A) to “STOP” position.

WARNING

If engine does not stop when stop switch is moved to STOP posi-

tion, close choke - COLD START position - to stall engine. Have

your ECHO dealer repair stop switch before using blower again.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sin comentarios

Echo SHRED'N'VAC ES-210 Manual de usuario Pagina 13