Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to chan
10 X7722271407© 4/2013 ECHO Inc.EMISSION CONTROL (EXHAUST & EVAPORATIVE) SRM-225UEMISSION CONTROL (EXHAUST & EVAPORATIVE)EPA 2010 and Later an
SRM-225U DESCRIPTIONX7722271407 11© 4/2013 ECHO Inc.DESCRIPTIONLocate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you
12 X7722271407© 4/2013 ECHO Inc.DESCRIPTION SRM-225U1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.2. TH
SRM-225U CONTENTSX7722271407 13© 4/2013 ECHO Inc.CONTENTSThe ECHO product you purchased has been factory pre-assembled for your convenience. Due to pa
14 X7722271407© 4/2013 ECHO Inc.ASSEMBLY SRM-225UASSEMBLYPlastic Shield Installation(Nylon line operation)The plastic shield is for use with the Nylon
SRM-225U ASSEMBLYX7722271407 15© 4/2013 ECHO Inc.3. Thread line head (J) onto PTO shaft by turning it counter-clockwise until head is tight against up
16 X7722271407© 4/2013 ECHO Inc.ASSEMBLY SRM-225Ua. Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool
SRM-225U ASSEMBLYX7722271407 17© 4/2013 ECHO Inc.4. Insert Cotter Pin (C) in hole in PTO shaft, and bend pin legs around shaft counterclockwise to ret
18 X7722271407© 4/2013 ECHO Inc.ASSEMBLY SRM-225U4. Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 ignition leads (F, G) on engi
SRM-225U OPERATIONX7722271407 19© 4/2013 ECHO Inc.OPERATIONMoving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose
2 X7722271407© 4/2013 ECHO Inc.TABLE OF CONTENTS SRM-225UTABLE OF CONTENTSTable of Contents ...
20 X7722271407© 4/2013 ECHO Inc.OPERATION SRM-225UNote: The Barrier Bar is used to restrict rearward movement of the unit. The Barrier Bar is NOT A HA
SRM-225U OPERATIONX7722271407 21© 4/2013 ECHO Inc.Note: In case of Emergency, pull up on the Quick Release Collar to disconnect the trimmer from the
22 X7722271407© 4/2013 ECHO Inc.OPERATION SRM-225U• Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is
SRM-225U OPERATIONX7722271407 23© 4/2013 ECHO Inc.Starting Cold EngineThe attachment will operate immediately when the engine starts, and could result
24 X7722271407© 4/2013 ECHO Inc.OPERATION SRM-225UStarting Warm EngineThe starting procedure is the same as Cold Start except DO NOT close the choke,
SRM-225U MAINTENANCEX7722271407 25© 4/2013 ECHO Inc.MAINTENANCEMoving parts can amputate fingers or cause severe injuries. Keep hands, clothing and lo
26 X7722271407© 4/2013 ECHO Inc.MAINTENANCE SRM-225UAir FilterLevel 1.1. Close choke (Cold Start Position [ ]). This prevents dirt from entering the c
SRM-225U MAINTENANCEX7722271407 27© 4/2013 ECHO Inc.Spark PlugLevel 2.Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) otherwise severe engine damag
28 X7722271407© 4/2013 ECHO Inc.MAINTENANCE SRM-225U2. Remove air cleaner cover (A).3. Remove engine cover (B).DO NOT use a metal scraper to remove di
SRM-225U MAINTENANCEX7722271407 29© 4/2013 ECHO Inc.Exhaust Port CleaningLevel 2.1. Remove spark plug lead from spark plug, and remove engine cover.2.
SRM-225U TABLE OF CONTENTSX7722271407 3© 4/2013 ECHO Inc.Storage ...
30 X7722271407© 4/2013 ECHO Inc.MAINTENANCE SRM-225UNote: Every unit is run at the factory and the carburetor is set in compliance with emission regu
SRM-225U MAINTENANCEX7722271407 31© 4/2013 ECHO Inc.Nylon Line Head Disassembly InstructionsNote: For normal use, Speed Feed© head disassembly is not
32 X7722271407© 4/2013 ECHO Inc.MAINTENANCE SRM-225UWhen the wear indicators located at the bottom of the Speed-Feed® head are worn smooth, or if hole
SRM-225U MAINTENANCEX7722271407 33© 4/2013 ECHO Inc.3. After sharpening teeth, check each tooth radius for evidence of a square (sharp) corner. Use th
34 X7722271407© 4/2013 ECHO Inc.TROUBLESHOOTING SRM-225UTROUBLESHOOTING Fuel vapors are extremely flammable and may cause fire and/or explosion. Never
SRM-225U STORAGEX7722271407 35© 4/2013 ECHO Inc.STORAGE During operation the muffler or catalytic muffler and surrounding cover become hot. Always kee
36 X7722271407© 4/2013 ECHO Inc.SPECIFICATIONS SRM-225USPECIFICATIONSMODEL SRM-225ULength 1793 mm (70.6 in.) Width 700 mm (27.5 in.) Height 510 mm (20
SRM-225U WARRANTY STATEMENTSX7722271407 37© 4/2013 ECHO Inc.WARRANTY STATEMENTSECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGI
38 X7722271407© 4/2013 ECHO Inc.WARRANTY STATEMENTS SRM-225U PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES
SRM-225U NOTESX7722271407 39© 4/2013 ECHO Inc.NOTES
4 X7722271407© 4/2013 ECHO Inc.INTRODUCTION SRM-225UINTRODUCTIONWelcome to the ECHO family. This ECHO product was designed and manufactured to provide
ECHO, INCORPORATED400 Oakwood RoadLake Zurich, IL 60047www.echo-usa.com40S79111001030/S79111999999S79012004906/S79012999999
SRM-225U SAFETYX7722271407 5© 4/2013 ECHO Inc.Additional or Replacement ManualsReplacement Operator, Safety Manuals, and Parts Catalogs are available
6 X7722271407© 4/2013 ECHO Inc.SAFETY SRM-225UInternational SymbolsPersonal Condition and Safety EquipmentUsers of this product risk injury to themsel
SRM-225U SAFETYX7722271407 7© 4/2013 ECHO Inc.Hand ProtectionWear no-slip, heavy duty work gloves to improve your grip on the handles. Gloves also red
8 X7722271407© 4/2013 ECHO Inc.SAFETY SRM-225U• Maintain good blood circulation by performing vigorous arm exercises during frequent work breaks, and
SRM-225U SAFETYX7722271407 9© 4/2013 ECHO Inc.Keep a Solid Stance• Maintain footing and balance at all times. Do not stand on slippery, uneven or unst
Comentarios a estos manuales